给料机应按规定的安装方法安装在固定的基础上。移动式给料机正式运行前应将轮子用三角木楔住或用制动器刹住。以免工作中发生走动，有多台给料机平行作业时，机与机之间，机与墙之间应有一米的通道。
给料机使用前须检查各运转部分、胶带搭扣和承载装置是否正常，防护设备是否齐全。胶带的涨紧度须在启动前调整到合适的程度。
皮带给料机应空载启动。等运转正常后方可入料。禁止先入料后开车。
有数台给料机串联运行时，应从卸料端开始，顺序起动。全部正常运转后，方可入料。
运行中出现胶带跑偏现象时，应停车调整，不得勉强使用，以免磨损边缘和增加负荷。
工作环境及被送物料温度不得高于50℃和低于-10℃。不得输送具有酸碱性油类和有机溶剂成份的物料。
输送带上禁止行人或乘人。
停车前必须先停止入料，等皮带上存料卸尽方可停车。
给料机电动机必须绝缘良好。移动
The feeder should be required for the installation method to install on a regular basis. Mobile feeder wheels should be before the official run using triangular wedge or with a brake check. So that move, the parallel operation of a plurality of feeder and between machine and machine, between the machine and the wall should be one metre of the channel.
给料机使用前须检查各运转部分、胶带搭扣和承载装置是否正常，防护设备是否齐全。胶带的涨紧度须在启动前调整到合适的程度。
The feeder shall inspect all machinery, belt buckle, and the bearing device is normal before use, protective equipment are complete. The tightness of the belt should be adjusted to the appropriate level before the start.
皮带给料机应空载启动。等运转正常后方可入料。禁止先入料后开车。
The belt feeder should be no-load start. And other normal operation can be entered into the rear. Prohibition of driving after the first entry.
有数台给料机串联运行时，应从卸料端开始，顺序起动。全部正常运转后，方可入料。
A plurality of feeder series operation, starting from the discharge end, sequential start. After all normal operation, can be entered into the material.
运行中出现胶带跑偏现象时，应停车调整，不得勉强使用，以免磨损边缘和增加负荷。
Belt deviation occurs during the operation, the parking should be adjusted, shall not be reluctant to use, to avoid edge wear and increase the load.
工作环境及被送物料温度不得高于50℃和低于-10℃。不得输送具有酸碱性油类和有机溶剂成份的物料。
The working environment and the material temperature of the material are not higher than 50 and lower than -10. Shall not be transported with the acid base oil and organic solvent ingredients.
输送带上禁止行人或乘人。
The conveyor belt is prohibited from pedestrians or passengers.
停车前必须先停止入料，等皮带上存料卸尽方可停车。
Parking must be stopped before entering the material, and other belt feeding and unloading to stop.
给料机电动机必须绝缘良好。移动式给料机电缆不要乱拉和拖动。电动机要可靠接地。
The motor must be well insulated feeder. Mobile feeder cables don't pull and drag. Motor to reliable grounding.
皮带打滑时严禁用手去拉动皮带，以免发生事故。
When the belt is slippery, it is forbidden to use the hand to pull the belt, so as to avoid the accident.
式给料机电缆不要乱拉和拖动。电动机要可靠接地。
皮带打滑时严禁用手去拉动皮带，以免发生事故。
|
